Maintenance
Before doing maintenance on the machine, disconnect it from the electrical supply by pulling out the plug or switching off the main switch! Failure to comply may cause serious injury.
Good saw operation requires periodic preventive maintenance.
1.Keep the inside of the cabinet and trunnion areas clean. A stiff brush will remove sawdust before it cakes, and pitch or gum is easily removed with a commercial solvent.
2.After cleaning the tilting and raising worm, and worm gear segments, and the
trunnions, grease these three areas with a good grade
3.The table surface must be kept clean and free of rust for best results. An occasional coat of paste wax on the table will allow the wood stock to glide smoothly across the work surface.
An alternative is white talcum powder applied with a blackboard eraser rubbed in vigorously once a week to fill casting pores and form a moisture barrier. This method provides a table top that is slick and allows rust rings to be easily wiped from the surface. It is also important to note that talcum powder will not stain wood or mar finishes as wax pickup can.
Optional Accessories
708295 | Tenoning Jig |
709380 | Zero Clearance Insert |
708818 | Push Stick |
709721 | Featherboard |
2042367 | Mobile base for Model 64A with 50” Rip Capacity, Ext. Table and Legs |
2042370 | Mobile base for Model 64A with 30” Rip Capacity, Ext. Table and Legs |
2195076K
2195077K
6290550 | Miter Gauge |
| |
6290694 | Table insert. |
| |
6290695 | Dado insert. |
| |
6441000Z | Legs, set of two. |
| |
6682004 |
| ||
6827029 | Model 64A | 27" x | |
6827033 | Model 64A | 27" x | |
6827034 | Model 64A | 27" x | 17” Extension Table for |
6827036 | Model 64A | 27" x | 17” Extension Table |
26