Powermatic pm1000 operating instructions Riving knife alignment, Lateral alignment

Page 18

Figure 21

9.5.2Tilt stop 45°

Repeat steps 1 through 4 above for 45° setting, as shown in Figure 22. Loosen nut (B1) with 11mm wrench, and turn set screw (B2) with a hex key the needed amount. Retighten nut (B1).

Figure 22

9.6Riving knife alignment

9.6.1Lateral alignment

The saw blade and riving knife must be in line as close as possible with each other (lateral alignment) for the prevention of kickback. Upon initial blade guard and riving knife installation no further adjustment should be necessary. Alignment should be checked and adjusted, if required, after each blade change.

Check the alignment as follows:

1.Remove blade guard, pawl assemblies, and table insert.

2.Place a straightedge (A, Figure 23) on the table so it rests against blade (B) and riving knife (C). Rotate blade so that top of blade tooth touches straightedge.

Figure 23

The saw blade and riving knife must be in line. If adjustment is needed:

3.Pull quick-release lever (A, Figure 24) and remove riving knife, making note as to which direction riving knife needs to be moved to align it with saw blade.

4.Use a 3mm hex key to make adjustments to four set screws (D, Figure 25) accessible through openings located in the corners of the clamp plate (B, Figure 25).

5.Adjust any number of setscrews required to bring riving knife in alignment with saw blade. Then reinsert riving knife, secure by tightening lever (A) and check the alignment per step 2.

6.Repeat steps 3–5 until alignment is correct.

Figure 24

Figure 25

18

Image 18
Contents Powermatic Part No. M-1791000Warranty and Service Warranty PeriodTable of contents Safety warnings Kickback Kickback PreventionProtection Tips from Kickback About this manual Glossary Specifications Subject to local/national electrical codesCfm 18 cmm Tools required for assembly Setup and assemblyShipping contents Unpacking and cleanupInstalling handwheels and hooks Installing table extensionsLeveling table extensions Wood Extension Table Switch bracketRails and Fence Motor coverInstalling and removing blade Riving knifeBlade guard Electrical connectionsAnti-kickback pawls Dust chuteVoltage conversion Overload reset buttonMagnetic switch and safety key Extension cordsFence alignment AdjustmentsTools required for adjustments Blade raising/tilt mechanismCalibration Blade tilt stop adjustmentExtension plate Tilt stopRiving knife alignment Lateral alignmentBlade proximity alignment Belt adjustmentTable to blade alignment Belt tensionBelt replacement OperationsArbor/Arbor Bearing Removal Rip sawing Resawing CrosscuttingBevel and miter operations Dado cuttingDo not use the standard table insert for dadoing operations Safety devices Feather boardFiller piece Push stick and push block Push Block TemplateLubrication MaintenanceCleaning MiscellaneousOptional accessories # 708097 Dado InsertTroubleshooting the PM1000 Cabinet Saw Symptom Probable Cause RemedyReplacement Parts 15.1.1 PM1000 Table and Cabinet Assembly Exploded View 15.1.2 PM1000 Table and Cabinet Assembly Parts List Index No Description Size QtyIndex No. Part No Description Size Qty 15.2.1 PM1000 Motor and Trunnion Assembly Exploded View 15.2.2 PM1000 Motor and Trunnion Assembly Parts List PM1000-115RCCJTAS10L-179-3 15.3.1 PM1000 Blade Guard Assembly Exploded View 15.3.2 PM1000 Blade Guard Assembly Parts List PM1000-AKPAElectrical Connections for PM1000 This page intentionally left blank New Sanford Road LaVergne, Tennessee