Powermatic pm1000 operating instructions Installing and removing blade, Riving knife

Page 13

Figure 9

NOTE: If while lowering blade, the points on the anti-kickback pawls tend to catch in the seam between table and table insert, slightly raise that area of table insert above main table surface.

7.12Installing and removing blade

A blade is not provided with the PM1000.

Use care when working with or

around sharp saw blades to prevent injury.

Refer to Figures 10 and 11.

1.Disconnect machine from power source.

2.Remove table insert.

4.Raise blade arbor all the way up, and set blade tilt to 0°. Tighten handwheel locking knob.

5.Press arbor lock pin (C) and rotate arbor to engage pin into slot in the arbor. Simultaneously remove arbor nut (A); loosen with arbor wrench if necessary.

6.Remove flange (B).

7.Install blade onto arbor, making sure the teeth point downward toward front of saw.

8.Install flange (B) and nut (A).

9.Engage arbor lock (C) and tighten nut (A) with provided arbor wrench.

Figure 10

Figure 11 (blade not provided)

7.13Riving knife

Refer to Figure 12.

To install riving knife:

1.Remove table insert.

2.Raise blade arbor all the way up and set tilt to 0° position.

3.Pull quick-release lever (G, Figure 12) to open position. The clamp plate (F) is spring loaded and will move away from the bracket (E), leaving a gap.

Figure 12

4.Slide prongs of riving knife (D) into slot between bracket (E, Figure 12) and clamp plate (F), and push riving knife down as far as it will go.

5.Push lever (G) to closed position.

13

Image 13
Contents Part No. M-1791000 PowermaticWarranty Period Warranty and ServiceTable of contents Safety warnings Kickback Prevention KickbackProtection Tips from Kickback About this manual Glossary Subject to local/national electrical codes SpecificationsCfm 18 cmm Shipping contents Setup and assemblyTools required for assembly Unpacking and cleanupInstalling table extensions Installing handwheels and hooksLeveling table extensions Rails and Fence Switch bracketWood Extension Table Motor coverRiving knife Installing and removing bladeAnti-kickback pawls Electrical connectionsBlade guard Dust chuteMagnetic switch and safety key Overload reset buttonVoltage conversion Extension cordsTools required for adjustments AdjustmentsFence alignment Blade raising/tilt mechanismExtension plate Blade tilt stop adjustmentCalibration Tilt stopLateral alignment Riving knife alignmentTable to blade alignment Belt adjustmentBlade proximity alignment Belt tensionOperations Belt replacementArbor/Arbor Bearing Removal Rip sawing Crosscutting ResawingDado cutting Bevel and miter operationsDo not use the standard table insert for dadoing operations Feather board Safety devicesFiller piece Push Block Template Push stick and push blockCleaning MaintenanceLubrication Miscellaneous# 708097 Dado Insert Optional accessoriesSymptom Probable Cause Remedy Troubleshooting the PM1000 Cabinet SawReplacement Parts 15.1.1 PM1000 Table and Cabinet Assembly Exploded View Index No Description Size Qty 15.1.2 PM1000 Table and Cabinet Assembly Parts ListIndex No. Part No Description Size Qty 15.2.1 PM1000 Motor and Trunnion Assembly Exploded View PM1000-115RCC 15.2.2 PM1000 Motor and Trunnion Assembly Parts ListJTAS10L-179-3 15.3.1 PM1000 Blade Guard Assembly Exploded View PM1000-AKPA 15.3.2 PM1000 Blade Guard Assembly Parts ListElectrical Connections for PM1000 This page intentionally left blank New Sanford Road LaVergne, Tennessee