Powermatic pm1000 operating instructions Replacement Parts

Symptom	Probable Cause	Remedy
	Tilting or raising lock knobs not	Tighten lock knobs on handwheels
	tightened.
	Machine not resting evenly on floor.	Make sure floor is level; use shims beneath
		cabinet if needed.
Excessive vibration.	Blade out of balance.	Replace blade.
	Pulley loose.	Check	motor	pulley and	spindle	pulley.
		Tighten set screws if needed.
	Belt is worn, cracked or frayed.	Replace belt.
	Motor not functioning properly.	Have	motor	checked	by a	qualified
		inspector. Repair or replace.
Blade not square with	Blade is warped.	Replace saw blade.
miter slot, or fence not
	Table top not parallel to blade.	Adjust table parallel to blade.
square to blade.
	Fence not parallel to blade.	Adjust fence parallel to blade.
Blade does not reach 90	90 degree stop is out of adjustment.	Adjust 90 degree stop.
degrees.
	Pointer bracket is hitting before the	File down the right side of pointer bracket
	blade reaches 90 degrees.	until blade can reach 90 degrees.
Cuts out-of-square when	Miter gauge out of adjustment.	Re-set stops and pointer on gauge.
crosscutting.	Miter slot misaligned.	Realign table to blade.
Cuts not true at 90 or 45	Stop screws not set properly.	Readjust screws.
degrees.
	Lock knob not released.	Loosen lock knob.
Tilting or raising
	Worm and trunnion segment caked	Clean and re-grease worm and segment.
handwheel difficult to
	with sawdust and pitch.
turn.	Worm and trunnion segment out of	Realign worm with segment.
	alignment.

15.0Replacement Parts

Replacement parts are listed on the following pages. To order parts or reach our service department, call 1- 800-274-6848 Monday through Friday (see our website for business hours, www.powwermatic.com). Having the Model Number and Serial Number of your machine available when you call will allow us to serve you quickly and accurately.

29