3. Tighten the four socket head cap screws.
Installing Switch
1.Remove any protective wrapping from the switch.
2.Remove the two socket head cap screws from their holes on the left side of the frame with a 5mm hex wrench. See Figure 4.
3.Place the flange of the switch box over the holes, and
4.Tighten both socket head cap screws.
Installing Dust Hood
1.Open the cabinet door and pull out the dust hood, which is connected to a hose.
2.Loosen the two socket head cap screws on the front of the headstock (Figure 5) with a 4mm hex wrench.
3.Slide the flanges of the dust hood behind the screws and flat washers as shown.
4.Tighten both socket head cap screws.
Installing Clamping Handles
There are two hubs at the right side of the machine which are used for clamping (Figure 6). Screw one clamp handle into a threaded hole on each hub. (Each hub has three such holes – choose one that will prevent the clamping handles from conflicting with each other.)
When the clamping handles are screwed in completely, tighten the hex nuts against the hubs with a 19mm wrench.
Dust Collection
The use of a dust collection system is recommended for this machine. It will help keep your shop clean as well as minimize any health risks caused by wood dust. Make sure your dust collector has a capacity of at least 500 CFM. Connect the intake hose of your dust collector to the 4” diameter port at the back of the cabinet. See Figure 7.
NOTE: A wide variety of dust collection systems are available from WMH Tool Group. Call customer service at
Figure 4
Figure 5
Figure 6
Figure 7
10