Replacements and Installations
Installing the FAN SHAFT ASSEMBLY
FAN BELT | MECHANISM BELT |
|
A091_4015BCA
A091_4015BA
Important
When installing the FAN and MECHANISM BELTS, install the MECHANISM BELT on the small MOTOR PULLEY, and the FAN BELT on the large MOTOR PULLEY.
[1]Do the removal procedure for the FAN BELT and SHAFT in reverse order.
Replacing the MOTOR
SCREW (3)
| Warning |
Dangerous Voltage | |
[1] | Disconnect the main power. |
[2] | Do the replacement procedure for the LOWER |
| HOUSING ASSEMBLY. |
[3] | Disconnect all wires from the MOTOR. |
[4] | Cut the 2 WIRE TIES on the SMALL CIRCUIT |
| BOARD between the MOTOR and MECHANISM |
MOTOR | ASSEMBLY. |
| |
[5] | Disconnect the 2 wires from the CYCLE |
| SOLENOID on the SMALL CIRCUIT BOARD. |
[6] | Pull the SMALL CIRCUIT BOARD up. |
[7] | Disconnect all wires on the MOTOR. |
[8] | Remove 3 Hex 1/4 in. SCREWS from the MOTOR. |
[9] | Lift the MOTOR up to allow access to the FAN and |
| MECHANISM BELTS. |
[10] | Remove the FAN and MECHANISM BELTS from |
| the MOTOR PULLEY. |
[11] | Remove the MOTOR. |
A091_4016GCA
A091_4016GA
7 |
