Replacements and Installations

Replacing the FAN SHAFT ASSEMBLY

WIRE TIE (not shown)

BR and KK models

BLOWER COVER WIRE TIE

GRILLE ASSEMBLY

A100_0013HCA

A100_0013HA

Warning

Dangerous Voltage

[1]Disconnect the main power.

[2]Do the replacement procedure for the LOWER HOUSING ASSEMBLY.

[3]Cut the 3 WIRE TIES:

1 on BLOWER COVER wires

2 on SMALL CIRCUIT BOARD between the MOTOR and MECHANISM ASSEMBLY

[4]Disconnect the 2 wires from the CYCLE SOLENOID on the SMALL CIRCUIT BOARD.

[5]Pull the SMALL CIRCUIT BOARD up.

[6]Remove the Torx SCREW from the BLOWER COVER ASSEMBLY.

[7]Lift the GRILLE ASSEMBLY in front of the BLOWER COVER ASSEMBLY up.

[8]Loosen the Torx SCREW on the right track of the LOWER LIGHT BAFFLE ASSEMBLY appoximately half way.

[9]Lift the LOWER LIGHT BAFFLE ASSEMBLY off the TAB on the BLOWER COVER ASSEMBLY.

[10]Remove the 2 long Torx SCREWS from the BLOWER COVER ASSEMBLY.

SM4530-1 – 30APR96

5

Page 5
Image 5
Kodak E-PLUS SLIDE, KKE PLUS Replacing the FAN Shaft Assembly, Remove the Torx Screw from the Blower Cover Assembly