Kodak J-E PLUS, KKE PLUS Adjusting the Focus Light Path Auto Focus Models, Adjustment Tool

Adjustments

Adjusting the Focus Light Path - Auto Focus Models

ADJUSTMENT TOOL

TL-3005 or

SPRING HOOK TL-1165

AUTO FOCUS

BRACKET

ASSEMBLY

light path

image

A091_4026HCA

AUTO-FOCUS TARGET SLIDE TL-3002 A091_4026HA

Warning

Dangerous Voltage

[1]Disconnect the main power.

[2]Remove the PROJECTION LENS.

[3]Do the removal for the LOWER HOUSING ASSEMBLY.

Important

It is necessary to make a FAN COVER TOOL. See the Tools section.

[4]Install the FAN COVER TOOL over the FAN area and the LAMP MODULE.

[5]Energize the projector.

[6]Set the projector to the LOW LAMP position.

[7]Install the AUTO-FOCUS TARGET SLIDE TL-3002 until it is fully seated in the GATE MECHANISM.

[8]Look through the PROJECTION LENS hole and observe the focus light path on the AUTO-FOCUS TARGET SLIDE TL-3002.

[9]Check the position of the image on the AUTO-FOCUS TARGET SLIDE TL-3002.

[10]Bend the AUTO-FOCUS BRACKET ASSEMBLY MIRROR until the image is within the target on the TARGET SLIDE. Use ADJUSTMENT TOOL TL-3005 or the SPRING HOOK TL-1165.

Adjustment Specification

Use TL-3002 to observe the focus light path and check the light image. Use T-BAR TL-3003 to bend the PHOTOCELL BRACKET to move the NULL in the center if necessary.

SM4530-1 – 30APR96 31