FS2/FS2SP Concrete SAW Console Components

FS2/FS2SP CONCRETE SAW — CONSOLE COMPONENTS

Figure 5 displays the location of the various operational control features of the FS2/FS2SP saw. Features are dependent on the specificmodelsawselected.Thefunctionofeachconsolecomponent or indicator is explained below:

1. Emergency Stop Button – Push this stop button to stop the engine. Also acts as a fast and secure way to stop the engine in the event of an emergency.

2. Transmission Engage/Disengage Lever – Forward locking position engages transmission. Rear Locking position disengages transmission from rear axle and permits "free wheeling" (self-propelled models Only).

3. Water ON/OFF Valve – On position opens valve and permits water to flow from source through saw water hose. OFF position closes valve and halts the flow of water.

4. Throttle Lever – Pull the lever to increase engine RPM. Push lever to decrease engine RPM (electric start models only).

5. Choke Lever – Pull lever to assist when starting a cold engine. Push lever down after engine warms to disengage choke (electric start models).

6. AUX Switch (Rocker) – Auxiliary switch for future features (electric start models).

7. Light Switch – Push top of rocker switch to provide +12 VDC power (ON) to the external halogen light. Push bottom of rocker switch to remove (OFF) +12 VDC power from halogen light (electric start models).

8. Pump On Switch – Push top of rocker switch to provide (ON) +12 VDC power to the external water pump. Push bottom of rocker switch to remove (OFF) +12 VDC power from water pump (electric start models).

9. Digital Tachometer/Hourmeter – Indicates engine RPM and number of hours (operation) saw has been in use.

10. Raise/Lower Crank Handle – Physically orients saw (raises or lowers) depending on cranking direction (CW or CCW). One full turn equals 3/8". Turning the handle clockwise lowers the saw, turning the saw counter- clockwise raises the saw. The raise/lower crank handle is used in conjunction with the depth feed gauge.

11. Start Button – A spring loaded button, that when pressed actuates the engine start solenoid (electric start models only).

12. Depth Feed Gauge – Indicates the blade cutting depth in inches. To activate, first lower the blade via the crank handle until the blade touches the cutting surface. Then roll the depth feed dial until the face label reads zero.

13. Forward/Reverse Speed Lever – Controls forward and reverse speeds for self-propelled operation. Provides positive neutral for engine start. ALWAYS place transmission engage/disengage lever in the engage position before setting speed lever (self-propelled models only).

14. Handle Bar Locking Knobs – Loosen or tighten these two knobs when making adjustments to the handlebar(s). Turn handle(s) counter-clockwiseto loosen and clockwise to tighten.

Figure 5. Console Components

PAGE 16 — MQ-WHITEMAN FS2/FS2SP CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #2 (06/26/06)