Multiquip operation manual FS2/FS2SP Concrete SAW Inspection -GUARDS, Covers & Belts

FS2/FS2SP CONCRETE SAW — INSPECTION -GUARDS, COVERS & BELTS

3.Check V-belt tension (Figure 18) by using a tensionmeter (6.0 - 9.0 lbs.) against the inside belt at a mid point between the two pulleys, or by deflecting the center belt at a mid point 3/8” (10 mm) - 1/2” (13 mm).

5.If theV-belts becomes worn or loose, replace them by using the following V-belt part numbers listed in Table 6.

Table 6. V-Belts and Pulleys

Engine Size	V-Belt P/N	Pulley P/N	Blade Size
	15082 (4)	15420	14
8.5 -13 HP Engine
	13249 (4)	15421	20
	15897 (4)	15365	14
20 HP Engine
	15082 (4)	15366	20

Figure 18.V-Belt Tension

4.DO NOT over or under tension the V-belts. Severe damage can occur to the saw and engine crank shaft if the belts are over tensioned. A decrease of power to the blade and poor performance will result if the belts are under tensioned (loose on pulleys).

MQ-WHITEMAN FS2/FS2SP CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #2 (06/26/06) — PAGE 25