CONTACTS
FIGURE 4 | RECHARGE PORT |
RECHARGE LED
RELEASE
110 VOLT ACBUTTON WALL ADAPTOR
WITH CORD
To remove the battery pack from the appliance body for charging: Make sure the trigger switch is OFF. Press both battery pack release buttons at the same time. Pull the battery pack down away from the appliance body. Insert the barrel connector of the AC Adapter into the battery pack’s receptacle (Recharge Port). Plug the AC Adapter into a 110 VAC standard household receptacle. Observe the red LED lights. Charge for the recommended time. Do not overcharge! Disconnect and store the AC Recharge Adapter from the battery pack and AC source when not in use.
6.COMPRESSOR/TIRE INFLATOR
This 12 Volt DC compressor is the ultimate compressor for all Vehicles, Trailer Tires and recreational inflatables. Three different sized nozzles are supplied.
IMPORTANT: Read safety Instructions Carefully To Avoid Possible Injury Or Property Damage.
WARNINGS: The compressor is capable of inflating to 260 pounds per square inch (PSI) pressure (approximately 18 kg/cm). To avoid over- inflation, carefully follow instructions on articles to be inflated. Never exceed recommended pressures. Bursting articles can cause serious injury. Always check pressure with the pressure gauge. Never leave compressor unattended while in use. Allow unit to cool for five minutes after 10 minutes of continuous operation.
6.1 TIRE INFLATION OR PRODUCTS WITH A VALVE STEM
1.Place connector (chuck) on valve stem.
2.Push connector toward valve stem and close thumb latch.
3.Make sure connector is pushed on to valve stem as far as possible before closing thumb latch.
4.Turn on the compressor (for larger items the trigger can be latched)
8 |