Contents, Scope of Application, Specifications

1.0Scope of Application

2.0Specifications

3.0User Responsibility

4.0Standard Accessories

5.0Optional Accessories

6.0Assembly

7.0Mitre Fence Assembly

8.0Installation

9.0Operation/Settings

10.0 Cutting

11.0 Saw Dust Collection (optional accessory)

12.0 Crane Lifting

13.0 Safety Rules

14.0 Care and Maintenance

15.0 Wiring Diagrams

16.0 Spare Parts List and Drawing

1.0Scope of Application

-This site saw model BKS 400/BKS 450 has been designed to perform rip and cross cuts in wood having a square or rectangular cross section.

-Cross cuts should only be performed with the help of the mitre fence.

-Round stock or firewood should not be cut without an appropiate jig holding the work safely.

-The maximum/minimum blade diameters are 400/350 mm for model BKS 400 and 450/350 mm for model BKS 450.

2.0 Specifications

	BKS 400/3.1 WNB	BKS400/4.2 DNB	BKS450/4.75DNB

Table size	1000 x 665 mm	1000 x 665 mm	1000 x 665 mm
Table height from floor	850 mm	850 mm	850 mm
Depth of cut	127 mm	127 mm	152 mm
Motor speed 50/60 Hz	2800/3360 rpm	2800/3360 rpm	2800/3360 rpm
Cutting speed	58.5 m/sec	58.5 m/sec	66 m/sec
Motor capacity P1 S6 40%	3.1 kW	4.2 kW	4,75 kW
Motor capacity P2 S1 100%	1.5 kW	2.1 kW	2.4 kW
Voltage	1~ 220/240V	3~ 380/440V	3~ 380/440V
Mains fuse	1 x 16A	3 x 16A	3 x 16A
Max. saw blade diameter	400 mm	400 mm	450 mm
Min. saw blade diameter	350 mm	350 mm	350 mm
Saw blade bore	30 mm dia.	30 mm dia.	30 mm dia.

Note: Saw blade 450mm diameter requires 4.75kW motor. Use of 450mm blades with 3.1kW and 4.2kW motor voids factory warranty!

3.0 User Responsibility

This machine will perform in conformity with the description contained in the instructions provided. This machine must be checked periodically. Defective equipment (including service leads) should not be used. Parts that are broken, missing, plainly worn, distorted or contaminated, should be replaced immediately. Should such repair or replacement become necessary, it is recommended that such repairs are carried out by qualified persons approved by the equipment manufacturer or its representative. This machine or any of its parts should not be altered or changed from standard specifications. The user of this machine shall have the sole responsibility for any malfunction which results from improper repair by anyone other than qualified persons approved by the equipment manufacturer or its representatives.