9.3 Rip Fence Setting/Adjusting
Set rip fence to required width of cut. Distance from blade is shown on the rip fence scale.
-Lock rip fence in position by pushing the
-If rip fence is not required it can be hung to the bolt on the right leg.
Loosen scale fixing screw to adjust rip fence scale to give exact reading of width of cut.
Make trial cut to verify setting.
9.4 Saw Blade Guard
After loosening the starknob on the guard support brak- ket the complete guard assembly can be removed.
Risk of personal injury when saw is operated wi- thout blade guard in place!
Attention!
Remove/install blade guard only with blade at complete standstill.
Danger of injury!
Loosen the ratched lever to adjust the blade guard position. Set blade guard about 8mm/3/8“ higher than the workpiece’s thickness.
Attention! Set blade guard only with blade at complete standstill. Danger of injury!