Place guard support into guard support brak- | Install the hex. socket head screw holding the | Install bolt for holding the rip fence to front right |
ket. Align with blade and riving knife and to | push stick to the front left leg. Hardware: | leg. Use hex. nut M8 and bolt M8 |
exact 90 against the table by moving the not | 1 hex. socket head screw M6x30 |
|
yet fully tightened guard support bracket. Tigh- | 2 each hex. nut M6 |
|
ten. |
|
|
Note: An improperly set up guard support may |
|
|
cause personal injury to the operator. |
|
|
7.0 Mitre Fence Assembly
-Cross cuts and mitre cuts must not be carried out without a suitable
If no mitre fence is installed use the Sliding Carriage
Bolt guide rod brackets to front and rear of table. Use 4 each
hex. head bolt M8x16 hex. nut M8
Slide both plastic guide bushes onto guide rod, then bolt guide rod to brackets. Use 2 hex. head bolts M8x20.
Bolt mitre fence carrier to guide bushes. Use 8 raised countersunk tapping screws 4.8x22.
Screw vernier scale carrier to mitre fence car- rier with raised countersunk head tapping screw 4.8x13
Screw vernier scale to vernier scale carier with 2 each raised countersunk head tapping screw 2.9x6.5
Install adjustable backstop on mitre fence seg- ment. Hardware:
1 hex. head bolt M6x20
2 hex. nut M6
1 washer 6.4
Place wave spring washer onto fitting bolt and | Place mitre fence segment onto carrier and | Attach mitre scale to segment using 3 each |
plastic glide piece into mitre fence carrier. | screw fitting bolt through segment into glide | tapping screw 3.9x9.5 |
| piece. | washer 4.3 |
| Hardware: |
|
| fitting bolt SW 19x42 |
|
| spring washer 12 |
|
| plastic glide piece with threaded bush. |
|