General safety advice for electrical power tools
Special safety advice relating to grinding and disc-cutting
a)Always use the guard designed for the type of abrasive consumable you are using. Always use abrasive consumables approved for use with your electrical power tool. Abrasive consumables not approved for use with your electrical power tool cannot be adequately guarded and are unsafe.
b)Normative statement / advice for this tool is not applicable.
c)Abrasive consumables must be used only for their recommended purpos- es, For example: never grind with the side face of a cutting disc. Cutting discs are intended for removing material using the edge of the disc. Sideways forces on these abrasive consumables can cause them to break.
d)Always use an undamaged mounting flange of the correct size and shape for your selected grinding disc. Suitable flanges support the grinding disc and reduce the chance of it breaking. Flanges for cutting discs are different from the flanges for other abrasive discs.
e)Never use worn down abrasive con- sumables intended for larger electrical power tools. Abrasive consumables intended for larger electrical power tools are not designed for the faster rotational speeds of these smaller electrical power tools and could break.
Further special safety advice for disc-cutting
a)Avoid snagging the cutting disc and do not use too much contact pressure. Do not attempt to make excessively deep cuts. Overloading the cutting disc in- creases the load and the tendency of the disc to twist or snag in the cut, making kickback or disc breakage more likely.
b)Avoid the area in front of or behind the rotating cutting disc. If the cutting disc is moving away from you at the point of con- straint in the workpiece, then, in the event of
a kickback, the electrical power tool and the rotating disc may be thrown towards you.
c)If the cutting disc jams or you stop work for a while, switch the device off and hold it until the disc comes to a complete stop. Never attempt to pull the still rotating cutting disc out of the cut as this could cause kickback. Determine and rectify the reason for the jamming.
d)Do not switch on the device if the cut- ting disc is in the workpiece. Allow the cutting disc to reach full speed before carefully continuing with the cut. Otherwise the disc could snag, jump out of the workpiece or cause a kickback.
e)Support boards or workpieces whilst cutting to reduce the risk of kickback caused by a jammed cutting disc. Large workpieces may bend under their own weight. The workpiece must be supported to both sides of the cutting disc and particularly near the cutting disc and at the workpiece edge.
f)Be particularly careful when pocket cutting in existing walls or other areas where you cannot see what you are cutting into. The cutting disc plunged into the surface could cut through gas or water pipes, electricity cables or other objects and cause kickback.
Special safety advice for abrading using sandpaper
Do not use
Special safety advice for polishing
Do not use the polishing bonnet if it has any loose parts, in particular the fastening cords. Tuck the fastening cords
12 GB/IE/CY