General safety advice for electrical power tools / Operation
away or trim them. Loose fastening cords rotat- ing with the attachment could catch your fingers or become trapped in the workpiece.
Special safety advice for working with wire brushes
a)Bear in mind that wire brushes lose pieces of wire during normal use. Do not overload the wires by applying too much pressure. Flying pieces of wire can very easily penetrate thin clothing and / or skin.
b)Use a guard, if recommended, but make sure that the wire brush does not come into contact with the guard. The diameters of disc brushes and cup brushes can increase due to contact pressure and cen- tripetal forces.
Safety advice applicable specifically to cordless
When you use the drill / grinder wear the following protective equipment:
safety glasses and protective gloves. CAUTION! RISK OF INJURY! The tool
continues to rotate after it has been switched off! Avoid contact with rap- idly rotating drill / grinder components.
WARNING! Securely support the work- piece. Use clamps or a vice to grip the workpiece firmly. This is much safer than holding it in your hand.
WARNING! RISK OF INJURY! Never support yourself by placing your hands near or in front of the device or the workpiece surface. A slip can result in injury.
DANGER OF FIRE FROM FLYING SPARKS! Abrading metal creates flying sparks. For this reason, always
make sure that nobody is placed in any danger and that there are no inflammable materials near the working area.
WARNING! DUST HAZARD! Any harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person operating the device and to anyone near the work area.
Wear a dust mask!
WARNING! NOXIOUS FUMES! Ensure that there is adequate ventilation when machining surfaces containing plastic or cov- ered with paint, varnish etc.
Do not soak the materials or the surface you are about to work on with liquids containing solvents.
Avoid abrading paints containing lead or other substances hazardous to health.
Do not machine materials containing asbestos. Asbestos is a known carcinogen.
Avoid contact with moving sanding or grinding tools.
Do not machine moist materials or damp sur- faces.
NOTE! Do not allow the tool to come to a standstill by overloading it!
WARNING! RISK OF INJURY!
Switch the device off and allow it to come to a standstill before you put it down.
WARNING! Always keep the device clean, dry and free of oil or grease.
Operation
Never use the device for a purpose for which it was not intended or with
Charging the battery pack
NOTE! A battery pack that has been unused for a while or never been charged must be charged before reuse or first use.
The battery pack requires about
CAUTION! RISK OF INJURY! Always pull out the mains plug (mains adapter 9 ) before
GB/IE/CY 13