Operation
you insert the battery pack into or take it out of the charger.
Connect the adapter | 9 |
| to a mains socket. | |||
Insert the battery pack |
| into the charging | ||||
3 | ||||||
cradle | 8 | . This can only be inserted with the | ||||
correct polarity. |
|
|
| |||
The LED 10 lights up green whenever the bat-
tery pack | 3 | is in the charging cradle | 8 | and | |
the adapter |
| is connected to a mains socket. | |||
9 | |||||
CAUTION! Do not charge a battery pack for a second time in close succession. There is a danger of overcharging the battery pack.
Inserting / removing the battery pack into / out of the drill / grinder
Inserting the battery pack:
Set the ON / OFF switch | 1 | to position “0”. | |
Insert the battery pack |
| into the drill / grinder | |
3 | |||
until it engages. |
|
| |
Removing the battery pack:
Pressing the battery pack buttons 2 at the sides at the same time allows you to remove the battery pack 3 .
Inserting or replacing a tool / collet
Press the spindle lock 7 and keep it pressed. Rotate the clamping nut 5 until the lock engages.
Loosen the clamping nut 5 with the combina- tion key 23 .
If a tool is already inserted, remove it.
First insert the tool you wish to use through the clamping nut 5 before you insert it into the collet 18 suitable for the tool shaft.
Press the spindle lock 7 and keep it pressed. Insert the collet 18 into the threaded insert and tighten the clamping nut 5 on the thread using the combination key 23 .
NOTE: Use the screwdriver end of the combi- nation key 23 to release or tighten the screw of the mandrels 12 .
Switching on and off / Setting the speed range
Switching on / Setting the speed range: Set the ON / OFF switch 1 to a position between “2” and “10”.
Switching off:
Set the ON / OFF switch 1 to position “0”.
Advice on working with materials / Tools / Speed ranges
Use the highest speed when working on steel or iron with the milling bits.
Use a short trial on a test piece to determine the optimum rotational speed range for working on zinc, zinc alloy, aluminium, copper and lead.
Use the low speed range for working on plastics and
Use high speeds on wood.
Use the medium speed range for cleaning, polishing and buffing.
The following information shall be considered as recommendatory only. Learn by practical experience which tools and settings are the best for the materi- als you work with.
14 GB/IE/CY