Grizzly G0700 owner manual Miter Cutting, To perform a miter cut

Miter Cutting

The miter fence is graduated in 5˚ increments and can be angled anywhere between 45°L and 45°R.

The angle of the miter fence is adjusted by loosen- ing the lock handle (Figure 63), rotating the fence to the angle shown on the scale, then tightening the lock handle to secure it in place.

Lock Handle

Scale

Figure 63. Miter fence.

To perform a miter cut:

1.Install the miter fence on the sliding table.

2.Position the miter fence at the desired angle for the cut and lock it in place. Figures 64–65show the miter fence set up for 45° cuts in both directions.

-40-

Figure 64. Fence set-up for 45˚R cuts.

Figure 65. Fence set-up for 45°L cuts.

3.Position the flip stop according to the length of the workpiece you want to cut off to the left of the blade.

4.Load the workpiece onto the table saw (similar to Figure 65) and perform the cutting operation in the same manner as a crosscut.

Model G0700 (Mfg. since 8/09)