Grizzly G0700 owner manual Push Blocks, Using a Push Block, Making a Push Block

Push Blocks

When used correctly, a push block reduces the risk of injury by keeping hands away from the blade while cutting. In the event of an accident, a push block often takes the damage that would have otherwise happened to hands or fingers.

Using a Push Block

A push block can be used in place of or in addi- tion to a push stick for feeding workpieces into the blade. Due to their design, push blocks allow the operator to apply firm downward pressure on the workpiece that could not otherwise be achieved with a push stick.

The push block design on this page can be used in two different ways (see inset Figure below). Typically, the bottom of the push block is used until the end of the workpiece reaches the blade.

The notched end of the push block is then used to push the workpiece the rest of the way through the cut, keeping the operator's hands at a safe distance from the blade. A push stick is often used at the same time in the other hand to sup- port the workpiece during the cut (see "Using a Push Stick" on previous page).

Push Stick
Prohibition
Zone
Push Stick
Supporting
Blade	Push
Path
	Block
Feeding

Figure 90. Using a push block and push stick to

make a rip cut.

Making a Push Block	CAUTION: Bottom
	of handle must be
Use this template to make your own push block.	at least 4" above
	bottom of push
	block to keep
	hand away
	from blade.

Handle for firm grip

Figure 89. Side view of a push block in use.

Notch for use

as a push stick

Make push block with 1⁄2"–3⁄4" thick material

1⁄2" Grid

4"

CAUTION: Only use hardwood, sturdy plywood, or high-density plastic. Do not use softwood that

may break under pressure or metal that can break 1/4"–1/2"teeth from the blade!

Lip for pushing workpiece

9"−10" Minimum Length

Figure 91. Template for a shop-made push block (shown at 50% of full size).

Model G0700 (Mfg. since 8/09) -51-