Grizzly G0700 owner manual Rip Cutting with Sliding Table

Rip Cutting

This saw has the capability of rip cutting large panels, as shown in Figure 54. The sliding table removes the burden of sliding a large and heavy panel over a stationary table surface.

Figure 54. Rip cutting with the sliding table.

This saw also has the capability of rip cutting in the same manner as a traditional table saw, as shown Figure 55.

Figure 55. Traditional rip cutting.

Model G0700 (Mfg. since 8/09)

Rip Cutting with Sliding Table

1.Install the miter fence on the sliding table, as shown in Figure 56.

Figure 56. Miter fence mounting locations.

2.Adjust the fence angle to 0˚, using the angle scale on the miter gauge. If the cut requires extreme precision, adjust the miter fence as described in Squaring Miter Fence to Blade on Page 65.

3.Adjust the miter fence so it does not extend into the cutting path of the blade.

4.Set the flip stop to the desired width-of-cut.

5.Load the workpiece onto the table saw. The set up should look similar to Figure 54.

6.Adjust the height of the main blade approximately 1⁄8"–1⁄4" above the top of the workpiece.

7.Take all the necessary safety precautions, then perform the cutting operation.

-37-