Grizzly Model G0536 instruction manual Installing Blades, Test Run, To test run the scroll saw

Page 15

Installing Blades

To install the blade:

1.Disconnect the machine from the power source.

2.Feed the blade through the table and hook into the lower blade holder as shown in Figure 6. The blade teeth should face for- ward and down.

Figure 6. Blade attached to both holders.

(Guard removed for clarity)

3.Push down on the upper blade holder and slide the upper end of the blade into the hold- er. Make sure that the pins are seated into the grooves in both holders.

4.Increase the tension on the blade until the blade gives a musical sound when plucked.

Note—Determining correct blade tension is subjective and learned through experience. If the blade is loose, the blade will drift off the layout line when cutting and the scroll saw will be noisy and vibrate. If the blade is too tight, the blade could break causing serious injury. Properly tensioned blades will last longer and are less likely to break.

5.Replace the lower arm guard, the throat plate and lower the blade guard into position.

Note—The blade can be installed sideways to accommodate long workpieces.

Test Run

Once the assembly is complete, the machine needs to be tested. The purpose of the test run is to ensure that there are no problems.

To test run the scroll saw:

1.Remove all tools from the scroll saw.

2.Turn the variable speed setting down to 550 SPM.

3.Plug the saw into the power source. Flip the switch ON. Keep your finger ready to turn the scroll saw OFF.

4.Listen for any unusual noises, vibrations or rubbing. If anything sounds unusual, stop the saw immediately.

5.Disconnect the machine from the power source and find the source of the problem before operating further.

NOTE—If you cannot locate the source of an unusual noise or vibration, feel free to con- tact our service department for help.

Before starting the saw, make sure you have performed the preceding assembly and adjustment instructions, and you have read through the rest of the manual and are familiar with the various functions and safety issues associated with this machine. Failure to follow this warning could result in serious personal injury.

 

 

 

 

 

 

 

 

G0536 Scroll Saw

 

-13-

 

Image 15
Contents Scroll SAW Page Table Of Contents Safety Instructions For Power Tools SafetyDo not OVER-REACH. Keep proper Always USE Safety GLASSES. AlsoUSE Proper Extension CORD. Make Drugs or ALCOHOL. Full mental alertNever USE Your Scroll SAW with the Blade Guard Removed Additional Safety Instructions For Scroll SawsCommentary IntroductionVolt Circuit RequirementsGrounding Extension CordsOperation Machine Features Machine features G0536 Scroll Saw SET UP UnpackingG0536 Inventory Working Clearance Clean UpWeight Load Site ConsiderationsTo attach the scroll saw to a solid surface Beginning AssemblyMount Scroll Saw Attach Blade GuardInstalling Blades Test RunTo test run the scroll saw Blade Speed To adjust the blade speedOperations GeneralUpper blade holder G0536 Scroll Saw Changing BladesStraight Cuts Curved Cuts To make a straight cutTo make a curved cut Inside Cuts Bevel CutsTo make a bevel cut Personal injury MaintenanceMaintenance Safety Working TableReplacing Brushes LubricationTo do this may result Service AdjustmentsAbout Service Squaring TableReference Info Aftermarket AccessoriesG0536 Scroll Saw Description Machine Data Sheet Symptom Possible Cause Corrective Action Troubleshooting GuideWarranty & Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCCall Today For a Free Full Color Catalog