Grizzly Model G0536 USE Proper Extension CORD. Make, Always USE Safety GLASSES. Also

Safety Instructions For Power Tools

9.	USE PROPER EXTENSION CORD. Make					15. USE RECOMMENDED ACCESSORIES.
	sure your extension cord is in good condi-					Consult the owner’s manual for recommend-
	tion. Conductor size should be in accor-					ed accessories. The use of improper acces-
	dance with the chart below. The amperage					sories may cause risk of injury.
	rating should be listed on the motor or tool
	nameplate. An undersized cord will cause					16. REDUCE THE RISK OF UNINTENTIONAL
	a drop in line voltage resulting in loss of					STARTING. On machines with magnetic
	power and overheating. Your extension					contact starting switches there is a risk of
	cord must also contain a ground wire and					starting if the machine is bumped or jarred.
	plug pin. Always repair or replace exten-					Always disconnect from power source
	sion cords if they become damaged.					before adjusting or servicing. Make sure
	Minimum Gauge for Extension Cords					switch is in OFF position before reconnect-
						ing.
			LENGTH			17. CHECK DAMAGED PARTS. Before further
	AMP RATING	25ft		50ft	100ft
						use of the tool, a guard or other part that is
	0-6	16		16	16
						damaged should be carefully checked to
	7-10	16		16	14
						determine that it will operate properly and
	11-12	16		16	14
						perform its intended function. Check for
	13-16	14		12	12	alignment of moving parts, binding of moving
	17-20	12		12	10	parts, breakage of parts, mounting, and any
	21-30	10		10	No	other conditions that may affect its opera-
						tion. A guard or other part that is damaged
10.	WEAR PROPER APPAREL. DO NOT
						should be properly repaired or replaced.
	wear loose clothing, gloves, neckties,
	rings, bracelets, or other jewelry which					18. NEVER LEAVE TOOL RUNNING UNAT-
	may get caught in moving parts. Non-slip					TENDED. TURN POWER OFF. DO NOT
	footwear is recommended. Wear protec-					leave tool until it comes to a complete stop.
	tive hair covering to contain long hair.
11.	ALWAYS USE SAFETY GLASSES. Also					19. NEVER OPERATE A MACHINE WHEN
						TIRED, OR UNDER THE INFLUENCE OF
	use face or dust mask if cutting operation					DRUGS OR ALCOHOL. Full mental alert-
	is dusty. Everyday eyeglasses only have					ness is required at all times when running a
	impact resistant lenses, they are NOT					machine.
	safety glasses.
12.	SECURE WORK. Use clamps or a vise to					20. NEVER ALLOW UNSUPERVISED OR
						UNTRAINED PERSONNEL TO OPERATE
	hold work when practical. It’s safer than					THE MACHINE. Make sure any instructions
	using your hand and frees both hands to					you give in regards to machine operation are
	operate tool.					approved, correct, safe, and clearly under-
13.	DO NOT OVER-REACH. Keep proper					stood.
	footing and balance at all times.					21. IF AT ANY TIME YOU ARE EXPERIENC-
14.	MAINTAIN TOOLS WITH CARE. Keep					ING DIFFICULTIES performing the intended
						operation, stop using the machine! Then
	tools sharp and clean for best and safest					contact our service department or ask a
	performance. Follow instructions for lubri-					qualified expert how the operation should be
	cating and changing accessories.					performed.
G0536 Scroll Saw						-3-