Grizzly G9742 owner manual Blade Tracking, 11. GZViiVXiZZZYXnacYZg#, Blade GuidesdcPage

10. GZ^chiVaa i]Z WaVYZ \jVgYh! VcY VY_jhi i]Z WaVYZ\j^YZhVhYZhXg^WZY^cBlade Guides dcPage 22

11. GZ"ViiVX]i]Z[ZZYXna^cYZg#

Blade Tracking

The blade tracking has been properly set at the factory. The tracking will rarely need to be adjusted if the bandsaw is used properly.

To adjust the blade tracking on the bandsaw:

1.UNPLUG THE BANDSAW!

2.GV^hZ i]Z ]ZVYhidX` VcY adX` ^i ^c eaVXZ Wn ejh]^c\^ci]ZhV[Zinhide`cdW#

3.GZbdkZWdi]WaVYZ\j^YZVhhZbWa^Zh#

4.Open the wheel access cover.

5.Loosen, but do not remove the lower cap screw in the blade wheel tilting mechanism (Figure 40).

Tracking

Set Screw

Lower Cap Screw

Figure 40. Adjusting tracking set screw.

6.Relax the blade tension.

-30-

7.Adjust the tracking set screw with a 4mm hex wrench as shown in Figure 40, then tighten the cap screw loosened in Step 5.

I^\]iZc^c\ i]Z hZi hXgZl l^aa bdkZ i]Z WaVYZXadhZgidi]Zh]djaYZgd[i]Zl]ZZa#

AddhZc^c\ i]Z hZi hXgZl l^aa bdkZ i]Z WaVYZVlVn[gdbi]Zh]djaYZg#

8.Tension the blade.

9.Spin the wheel by hand and observe how the

blade tracks on the wheel.



>[ i]Z WaVYZ igVX`h Vadc\ i]Z h]djaYZg d[ i]Z l]ZZa l^i]dji gjWW^c\! i]Z WaVYZ ^h igVX`^c\ egdeZgan VcY i]^h VY_jhibZci ^h XdbeaZiZY#

—If the blade drifts away from the shoulder of the wheel or hits the shoulder, repeat Steps 5-8.

10.Replace the blade guard and blade guide assemblies.

11.6Y_jhii]ZWaVYZ\j^YZhVhcZZYZY#GZ[Zgid

Blade GuidesdcPage 22

G9742 5" x 6" Metal Cutting Bandsaw