Handles
The guard adjuster is used to secure the guard to the table and to allow the guard to be loosened for adjustment. To assemble the guard adjuster:
1.Install the bar into the guide shaft as shown in Figure 9.
2.Line up the groove in the bar with the setscrew.
Groove
Figure 9. Slide bar into guide shaft.
3.Tighten the shaft setscrew into the groove to lock the bar in place as shown in Figure 10.
4.Install the round knobs shown in Figure 11 onto both ends of the bar.
Figure 11. Thread round knobs onto bar.
The wheel shown in Figure 12 fits on the adjust- ment shaft. This locks in place by tightening the setscrew into the groove on the shaft. There is a threaded hole on the wheel that allows for the optional installation of a crank (not included). The completed assembly is used to adjust the fence.
Setscrew
Shaft | Setscrew Groove |
Groove |
|
Figure 12. Installing wheel onto adjustment guide.
Figure 10. Tightening setscrew with hex key.
G8622 Tilting Spindle Sliding Table Shaper |