4.With the provided washer, thread the adjustable handle through the miter gauge and into the table as shown in Figure 22.
Figure 22. Installing the adjustable handle.
5.Insert the the miter gauge pointer shown in Figure 23, but do not tighten the nearby setscrew at this time.
Figure 23. Installing the pointer.
6.Place flat washers on the miter fence hex bolts, then start the special nuts onto the ends. Slide the special nuts into the groove of the fence. The end piece for the fence works with the same special nut and hex bolt system. When these have all been installed on the miter fence, it is time to install the fence onto the miter gauge as in Figure 24.
Figure 24. Installing the miter fence.
7.Tighten the hex bolts that secure the fence to the miter gauge.
8.Slide the clamping unit onto the push shaft as shown in Figure 25.
Figure 25. Installing the clamping unit.
G8622 Tilting Spindle Sliding Table Shaper |