Grizzly G8622 instruction manual Hold-Downs Miter Assembly

Page 18

Hold-Downs

 

Miter Assembly

 

 

 

 

 

 

Hold-downs are used to hold the workpiece flat on the table and snug against the fence as shown in Figure 19. To assemble the spring hold- downs:

1.Slide a hold-down plate into each of the cast iron hold-down brackets.

2.Insert the bracket pole into the fence bracket and hold-down bracket.

3.Partially screw the handle into the hold-down brackets.

4.Position the hold-downs according to the size of your workpiece.

5.Tighten the handles to secure the hold- downs.

Figure 19. Hold-downs on workpiece.

-16-

The miter gauge for the Model G8622 features a clamp and special fence. The miter gauge assembly can be mounted on either end of the table, depending on the type of desired cut or cut- ting direction. To mount the miter gauge and its fence:

1.Locate the threaded holes on either side of the table.

2.Install the push shaft as shown in Figure 20.

Figure 20. Installing the push shaft.

3.Now, slide the miter gauge down the push shaft as in Figure 21.

Figure 21. Installing the miter gauge. G8622 Tilting Spindle Sliding Table Shaper

Image 18
Contents Sliding Table Tilting Spindle Shaper Page Table Of Contents Safety Safety Instructions For Power ToolsLength AMP Rating Additional Safety Instructions For Shapers Circuit Requirements 220V Operation GroundingExtension Cords Wiring General Information CommentaryUnpacking Miter Gauge Kit Hardware and QtyModel G8622 Hardware and Qty Clean Up Site ConsiderationsSwitch Pedestal AssemblyBeginning Assembly HandwheelSpindles SpindlesInstalling wheel onto adjustment guide HandlesGuard Fence Assembly Adjustable handle G8622 Tilting Spindle Sliding Table ShaperAttach wooden fence assembly Guard CoverHold-Downs Miter Assembly Page Adjustments Pulleys & V-BeltFence Adjustment Belt TensionSpeed Changes Aligning The Fences Setting Miter Gauge Tilting Spindle Table Insert Spindle tilt control and gaugeTest Run Operation RotationCutter Installation Table Lock Tightening spindle nutsSpindle Height Straight Shaping Location of spindle lockSee Figure Rub collar installed below cutter Rub CollarsPattern Work Freehand Shaping Miter gauge set to Fences opened for clarityShaper Accessories Locking down the miter clampLubrication MaintenanceGeneral BeltG8622 Tilting Spindle Sliding Table Shaper Closure Machine Data Sheet G8622 Tilting Spindle Sliding Table Shaper G8622 Tilting Spindle Sliding Table Shaper G8622 Tilting Spindle Sliding Table Shaper G8622 Tilting Spindle Sliding Table Shaper G8622 Tilting Spindle Sliding Table Shaper PSS23 Spindle 11⁄4 Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC Page Call Today For a Free Full Color Catalog