Grizzly G8622 instruction manual Circuit Requirements, 220V Operation Grounding

The Model G8622 Shaper is furnished with a 3450 R.P.M., 5 H.P., Single-Phase 220V motor, push-button ON/OFF magnetic starter switch, FORWARD/REVERSE switch and a cord set. Under normal use, the motor draws approximate- ly 25 amps @ 220V. We recommend a 30 amp circuit breaker. If frequent circuit failures occur when using the shaper, contact our service department.

The shaper motor must be connected to its own dedicated 30A circuit, including wires rated for 30 amps and a 30 amp circuit breaker. It should not share a circuit with any other machine. A stan- dard 2-pole breaker is necessary for use with the shaper.

We recommend using a NEMA-style L6-30 plug and outlet similar to that in Figure 1. You may also “hard-wire” the shaper directly to your panel, provided you place a disconnect near the machine. Check the electrical codes in your area for specifics on wiring requirements.

In the event of an electrical short, grounding reduces the risk of electric shock by providing electric current a path of least resistance to dis- perse electricity. This tool is equipped with an electric cord that has an equipment-grounding conductor which must be properly connected to a grounding plug. The plug must be plugged into a matching outlet that is properly installed and grounded in accordance with all local codes and ordinances.

Improper connections of the electrical-grounding conductor can result in the risk of electric shock. The conductor with green or green and yellow striped insulation is the electrical-grounding con- ductor. If repair or replacement of the electric cord or plug is necessary, do not connect the equipment grounding conductor to a live terminal.

This equipment must be grounded. Verify that any existing electrical outlet and circuit you intend to plug into is actually grounded. Under no cir- cumstances should the grounding pin from any three-pronged plug be removed. Serious injury may occur.