Grizzly H3390 instruction manual Blade Guard Lock Knob

Page 14

9.Attach the blade guard to the motor assem- bly using the M8-1.25 x 30 lock knob and M8 flat washer as shown in Figure 11. Tile saw blades are sold separately.

Blade Guard

Lock Knob

Figure 11. Attaching the blade guard.

10.Place the water pump inside the water reser- voir and plug the pump cord into the recepta- cle on the side of the motor assembly. A plas- tic hose runs from the pump to a “Y” connec- tor and then slides through two mounting holes on each side of the blade guard base (Figure 12).

“Y” Connector

Hose

Mounting

Holes

Water Pump

Figure 12. Lube system.

11.Slide the chrome table rail through the mounting holes on the table as shown in Figure 13.

Saw Table

Table Rail

Figure 13. Assembling the table rail.

12.Slide the silver aluminum rail cover over the rail as shown in Figure 14.

Rail Cover

Figure 14. Assembling the rail cover.

-12-

H3390 Wet Tile Saw

Page 13 Page 15
Image 14
Page 13 Page 15
Contents WET Tile SAW Page Table of Contents Safety Safety Instructions For Power ToolsLength AMP Rating 25ft 50ft 100ftSafety Instructions For Tile Saws Introduction CommentaryCircuit Requirements 110V OperationGrounding Extension Cord Site Considerations SET UPClean Up Main Features Right side of sawAssembly To assemble the sawWater Reservoir Saw Frame Blade Guard Lock Knob Attaching the rail/table assembly to Saw frame Blade ChangesStart Up Starting the machineTo set up the water lube system LubricationCutting OperationCut Preparation To make a cutTable fine-tuning cap screw Rip Fence 45˚ FenceMaintenance GeneralReference Info Machine Data Sheet Model H3390 10 Wet Tile SawH3390 Wet Tile Saw H3390 Wet Tile Saw Description H3390 Wet Tile Saw H3390 Wet Tile Saw Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC BOX BELLINGHAM, WAPage Call Today For a Free Full Color Catalog
Top Page Image Contents