3.Mount the saw frame to the stand using (2)
Figure 6. Mounting the saw frame to the stand.
4.Slide the plastic water reservoir into one end of the saw frame as shown in Figure 7. Be sure the reservoir is not protruding from either end of the frame.
Water Reservoir
Saw Frame
Figure 7. Installing the water reservoir.
5.Slide the pivot shaft into the riser block as shown in Figure 8. Be sure the notched end of the pivot shaft is positioned correctly.
6.Secure the assembly with a M10-1.5 x 10 setscrew as shown in Figure 8.
7.Slide the pivot shaft into the mounting holes on the motor assembly and secure with the blade height adjustment knob as shown in Figure 9.
H3390 Wet Tile Saw
Notch
Setscrew
Figure 8. Attaching the pivot shaft to the riser
block.
Mounting Holes |
Blade Height |
Adjustment Knob |