Figure 7.
Tool Rest
The tool rest is equipped with a
1.Remove the large hex nut and lock plate from the bottom of the tool rest assembly.
2.Set the tool rest assembly on the lathe bed with the clamp stud between the bed slot.
3.Set the tool rest lock handle so it is pointing down.
4.Lift the lock handle approximately 90˚ and tighten the hex nut 1⁄2 to 2⁄3 of a turn more.
5.Turn the tool rest lock handle until it locks the tool rest down onto the bed. You may need to adjust the hex nut in small increments to fine tune how the tool rest assembly locks down onto the bed.
Figure 8.
Tailstock
Thread the handle onto the tailstock handwheel and tighten down the jam nut (Figure 9).
Figure 9.
G1067Z Wood Lathe