3.Release the set pin. Make sure the set pin has engaged in its detent by trying to rotate the headstock.
4.Now position the head stock along the bed as desired and engage the quick release lever.
Never operate the lathe with the quick release lever loose. Serious personal injury may occur.
Figure 16. Headstock set at 90˚.
Figure 17. Headstock set at 180˚.
Tailstock
The tailstock is equipped with a
1.Loosen the quick release lever and move the tailstock to the desired position (Figure 18).
2.
3.If the quick release lever will not lock the tail- stock down onto the bed (either too loose or too tight), loosen or tighten the hex nut (located on the underside of the tailstock) in small increments as needed to achieve the proper clamping pressure.
Quick release lever
Figure 18.
|
|
|
|
|
|
|
|
|
|
|
|
G1067Z Wood Lathe |