Figure 3. Trunnion support in correct position.
3.Before you place the table on the trunnion support, install the blade guides and thumbscrews that hold them in place. See
Figure 4.
Figure 4. Installing blade guide assemblies.
4.Remove the tapered pin from the slot in the table edge.
5.Move the table past the blade through the table slot, rotate the table 90¡, and set the table trunnions onto the bracket. Make sure the trunnion bolts drop through the support bracket. Remember to position the table so that the miter slot is to the right of the blade as you face the front of the bandsaw.
6.Secure the table to the support bracket by securing the two trunnion knobs (shown in Figure 5) onto the trunnion bolts.
G4186Z 18" Bandsaw
7.Place the round table insert in the table top and replace the tapered pin so it fits snugly in the hole on the side of the table. Do not use excessive force.
The tapered table pin should always be in position when operating the bandsaw. Operating without the pin can allow a step in the table top which can catch your work- piece during cutting. Serious personal injury may occur if this caution is ignored.
Table Trunnions
Trunnion Knobs