WHEEL | PULLEYS |
| ALIGN |
LOWER |
|
| MOTOR |
Figure 24. Wheel to pulley alignment.
2.Adjust the belt tension by pivoting the motor along the circular slot. Proper tension is achieved when the belt can be deflected roughly 1/2" with moderate finger pressure.
3.Tighten the nuts and bolts securely. Recheck the belt tension and pulley align- ment.
Dust Collection
The G4186Z has an integral 4'' dust port built into the lower wheel housing. You will achieve the best results if you connect the machine to a dust collection system when you are using the saw. This helps to keep the blade and the wheels clear of chips and dust. Plus, there is the added bene- fit of having less dust put into the air of your shop. Connect your dust collection hose securely to this port using hose clamps, and activate the dust col- lection system at the time you start the bandsaw.
Changing Speeds
The Model G4186Z offers 3100 and 2000 F.P.M. speeds. To change the speed:
1.Unplug the bandsaw from the power sup- ply!
2.Loosen the lock bolt on the body of the bandsaw, near the motor.
3.Pivot the motor up to loosen the
4.Pivot the motor down and tighten the lock bolt. Proper tension is achieved when the belt can be deflected roughly 1/2" with mod- erate finger pressure. Check the belt ten- sion and adjust if necessary.
Figure 25. Wheel to pulley alignment.
|
|
|
|
|
|
|
|
|
| G4186Z 18" Bandsaw | |
|
|