SECTION 4: ASSEMBLY
Keep loose clothing out of the way of machinery and keep hair pulled back.
Disconnect power to the machine when perform- ing any maintenance or assembly. Failure to do this may result in serious personal injury.
Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.
Some metal parts may have sharp edges on them after they are formed. Please examine and file the edges of all metal parts before han- dling them. Failure to do so could result in injury.
Beginning Assembly
Most of your Model G4186Z Bandsaw has been assembled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented here.
TOOLS REQUIRED: You will need an adjustable square, 12mm and 14mm open end wrenches and a Phillips¨ and regular screwdriver.
Table and Support
Bracket
The bandsaw table comes with the table trun- nions already attached. These trunnions mount to the trunnion support bracket which needs to be mounted to the bandsaw unit before the table can be installed. To attach the bandsaw table:
1.Remove the two trunnion support bracket mounting bolts from the bandsaw body. Note the two alignment holes shown in Figure 2.
Alignment Pins
Figure 2. Alignment pins on bracket support.
2.Position the bracket over the alignment holes on the bandsaw body. Alignment pins are located on the bottom of the table sup- port bracket. Secure the bracket with the two bolts. See Figure 3.
|
|
|
|
|
|
|
|
|
| G4186Z 18" Bandsaw | |
|
|