Grizzly G1016 instruction manual VII. Assembly, Stand

Page 10

1st page of 5 page section

A. Stand

Note: All die-cut metal parts have a sharp edge (called “flashing”) on them after they are formed. This is removed at the factory. Sometimes, though, a bit of flashing might escape inspection. Please examine the edges of all die-cut metal parts before handling them.

TOOLS REQUIRED: Common hand tools are necessary to assemble this machine. You will need a set of open ended metric and stan- dard wrenches and a Phillips head screwdriv- er.

VII. Assembly

1.Flip the top of the stand upside down and place it on your benchtop.

2.Attach the sides using the carriage bolts, washers, and nuts provided. Mount the stand front (the side with the switch) so it is on the same side as the rectangular hole in the stand top. Figure 2. Do not fully tighten the nuts.

3.Mount the braces between the front and back panels. Use carriage bolts, wash- ers, and nuts provided. Tighten partially.

4.Press the 90° brackets onto the bottom corners of the stand. These are stiffen- ers.

90° Bracket

 

Rubber Foot

Front

Left Brace

 

Back

 

Primary Motor

 

Bracket

 

Motor

Motor Pulley

 

Right Brace

 

Stand Top Hole

 

Aux. Motor Bracket

Switch

 

Figure 2 shows the stand/motor assembly completed.

 

Hunter’s Meat Cutting Bandsaw - 7 -

Page 9 Page 11
Image 10
Page 9 Page 11
Contents HUNTER’S Meat Cutting SAW Table of Contents XII Introduction II. Safety Rules for all Tools Remember Safety First II. Safety Rules for all ToolsGrounding III. Electrical Service RequirementsCircuit Loading Word of CautionWorking Clearances IV. Site PlanningUnpacking Lighting and OutletsVI. Piece Inventory QTY Description LocationVII. Assembly StandMotor Bandsaw UnitPulleys and V-Belt To install and properly tension the V- BeltTo align the driven pulley Figure Column Guard Fence & GuardsFence Upper Wheel GuardMeat Grinder To install the meat grinder FigureTo install the stand enclosures Stand EnclosuresBlade Tension VIII. AdjustmentsTo adjust the blade tension To check blade tensionTracking To Adjust trackingTo Check tracking To adjust the lower guide tabs Figure To adjust the upper guide blocks FigureGuide Blocks To adjust the lower support bearing Figure To adjust the upper support bearing FigureSupport Bearings Blade Removal and Replacement Blade GuardIX. Safety Rules for Bandsaws General Cutting ProceduresOperations Test RunVII.D. and clean it. Use soap XI. CleaningTo clean your bandsaw To clean the meat grinderLubrication XII. MaintenanceMiscellaneous XIII. Troubleshooting Symptom Possible Cause Corrective ActionXIV. Main Parts Diagram XV. Meat Grinder Parts Diagram XVI. Stand Parts Diagram XVII. Parts List REF# PART# DescriptionXVIII. Machine Data Limited Warranty & Returns Policy
Top Page Image Contents