Grizzly G1016 instruction manual Fence & Guards, Column Guard, Upper Wheel Guard, Blade Guard

Page 13

VII. Assembly

E. Table

Before installing the table and guards, peel off the blue, protective plastic.

Slide the table on at a 45° angle. Figure 6. Lower the table so the notch goes around the column. When it is in its final position, secure it to the bandsaw body using the black knobs provided.

Column

Notch

Blade Slot

Figure 6 shows how to install the table.

-10 - Hunters Meat Cutting Bandsaw

4th page of 5 page section

F. Fence & Guards

Fence:

Install the fence so the vertical portion is fac- ing the blade. Figure 7. Secure it to the table and bandsaw body with the black knobs.

Column Guard:

Attach the column guard to the vertical col- umn. Use the black knobs. Figure 7.

Upper Wheel Guard:

Attach the upper wheel guard to the vertical column using a black knob. Figure 7.

Blade Guard:

Using the last 2 black knobs, secure the blade guard to the upper wheel guard. You may need to place washers behind the heads of the knobs so the threaded ends do not touch the blade. Extra washers are not provided.

Figure 7.

Upper Wheel Guard

Column

Guard

Blade Guard

Fence	Table

Figure 7 shows the fence, guards, and table installed correctly.

Image 13

Contents HUNTER’S Meat Cutting SAW Table of Contents XII Introduction II. Safety Rules for all Tools II. Safety Rules for all Tools Remember Safety FirstCircuit Loading III. Electrical Service RequirementsGrounding Word of CautionUnpacking IV. Site PlanningWorking Clearances Lighting and OutletsQTY Description Location VI. Piece InventoryStand VII. AssemblyBandsaw Unit MotorPulleys and V-Belt To install and properly tension the V- BeltTo align the driven pulley Figure Fence Fence & GuardsColumn Guard Upper Wheel GuardTo install the stand enclosures To install the meat grinder FigureMeat Grinder Stand EnclosuresTo adjust the blade tension VIII. AdjustmentsBlade Tension To check blade tensionTracking To Adjust trackingTo Check tracking To adjust the lower guide tabs Figure To adjust the upper guide blocks FigureGuide Blocks To adjust the lower support bearing Figure To adjust the upper support bearing FigureSupport Bearings Blade Guard Blade Removal and ReplacementIX. Safety Rules for Bandsaws Operations Cutting ProceduresGeneral Test RunTo clean your bandsaw XI. CleaningVII.D. and clean it. Use soap To clean the meat grinderLubrication XII. MaintenanceMiscellaneous Symptom Possible Cause Corrective Action XIII. TroubleshootingXIV. Main Parts Diagram XV. Meat Grinder Parts Diagram XVI. Stand Parts Diagram REF# PART# Description XVII. Parts ListXVIII. Machine Data Limited Warranty & Returns Policy