Grizzly G1016 instruction manual Support Bearings, To adjust the upper support bearing Figure

Page 18

4th page of 5 page section

D. Support Bearings

The support bearings back-up the blade dur- ing sawing. The upper support bearing is

VIII. Adjustments

located just above the guide blocks. Figure

13.The lower support bearing is perpendicu- lar (90°) to the upper bearing, but it should be adjusted similarly.

To adjust the upper support bearing (Figure 13):

1.Loosen the thumbscrew securing the upper support bearing shaft.

2.Position the bearing to approximately 1/64" behind the blade.

3.Re-tighten the thumbscrew.

To adjust the lower support bearing (Figure 14):

1.Loosen the nut that holds the lower sup- port bearing in place.

2.Position the bearing to approximately 1/64" behind the blade.

3.Re-tighten the nut that holds the bearing in place.

 

Fixed Plate

Guide Tab

 

Support Bearing

Guide Tab

 

Support Bearing Nut

Figure 14 shows a closeup of the lower guide assembly.

Hunter’s Meat Cutting Bandsaw - 15 -

Image 18
Contents HUNTER’S Meat Cutting SAW Table of Contents XII Introduction II. Safety Rules for all Tools Remember Safety First II. Safety Rules for all ToolsGrounding III. Electrical Service RequirementsCircuit Loading Word of CautionWorking Clearances IV. Site PlanningUnpacking Lighting and OutletsVI. Piece Inventory QTY Description LocationVII. Assembly StandMotor Bandsaw UnitTo install and properly tension the V- Belt Pulleys and V-BeltTo align the driven pulley Figure Column Guard Fence & GuardsFence Upper Wheel GuardMeat Grinder To install the meat grinder FigureTo install the stand enclosures Stand EnclosuresBlade Tension VIII. AdjustmentsTo adjust the blade tension To check blade tensionTo Adjust tracking TrackingTo Check tracking To adjust the upper guide blocks Figure To adjust the lower guide tabs FigureGuide Blocks To adjust the upper support bearing Figure To adjust the lower support bearing FigureSupport Bearings Blade Removal and Replacement Blade GuardIX. Safety Rules for Bandsaws General Cutting ProceduresOperations Test RunVII.D. and clean it. Use soap XI. CleaningTo clean your bandsaw To clean the meat grinderXII. Maintenance LubricationMiscellaneous XIII. Troubleshooting Symptom Possible Cause Corrective ActionXIV. Main Parts Diagram XV. Meat Grinder Parts Diagram XVI. Stand Parts Diagram XVII. Parts List REF# PART# DescriptionXVIII. Machine Data Limited Warranty & Returns Policy