Grizzly G9979 owner manual Adjusting Table Tilt, To adjust the table tilt

5.Slide the blade support (see Figure 29) up to, but not touching, the back of the blade, then re-tighten the blade support cap screw.

Blade Guide

Cap Screws

Air Nozzle

Blade Support

Figure 29. Blade guide assembly (upper assembly shown without blade for clarity).

6.Rotate the upper wheel by hand so that the blade weld is between the blade guides.

7.Use a 4mm hex wrench to loosen the blade guide cap screws (see Figure 29).

8.Fold a crisp dollar bill in half and place it over the blade (between the blade guides and the blade), as shown in Figure 30.

Figure 30. Using a dollar bill to set blade guide

spacing.

-32-

9.Lightly pinch the dollar bill against the blade with the blade guides, re-position the air nozzle if necessary, then re-tighten the blade guide cap screws.

Note: The goal is to position the blade guides as close as possible to the blade without touching it during operation.

Adjusting Table Tilt

To perform beveled cuts, the bandsaw table tilts 15° to the left and 45° to the right.

To adjust the table tilt:

1.DISCONNECT BANDSAW FROM POWER!

2.Use a 23mm wrench to loosen the hex nut underneath the rear of the table (see

Figure 31).

Table Tilt Scale

Hex Nut

Figure 31. Table tilt scale and hex nut.

3.Using the table tilt scale, adjust the angle of the table for your operation, then re-tighten the hex nut.

G8144Z/G8145Z/G8146Z (Manufactured Since 6/11)