Grizzly G7209 instruction manual Fence Rails, Using tape to shim for wing alignment

Page 16

5.Raise or lower the rear of the wing until the wing and table are flush. Tighten the bolt. Any adjustment at this point should be mini- mal.

6.Check flushness at the front bolt and read- just if necessary.

7.Repeat Steps 3-4for the other extension wing.

8.Now, check the alignment of the table and both wings with a straightedge. The straight- edge should run flat across both wings and the table top. If the straightedge contacts both wings and the table evenly, you are fin- ished with this section. If it does not, contin- ue to Step 9.

9.If the extension wings tilt up or down at the outside edges, remove the wings and shim them with masking tape. See Figure 7.

a.If the wings tilt down, stick layers of mask- ing tape under each bolt near the bottom edge of the wing and retighten.

b.If the wing tilts up, stick layers of masking tape above each bolt near the top edge of the wing and retighten. Allow tape to extend above table surface and trim with a sharp knife after final assembly.

10.Replace the wings and check again.

Masking Tape

Figure 7. Using tape to shim for wing alignment.

-14-

Fence Rails

1.Locate the rear fence rail (the shorter of the two rails).

2.Attach the rear rail to the table top using the spacers, hex bolts and lock washers sup- plied. See Figure 8. Using a combination square set at 15Ú32", place at the edge of the table, and adjust the rail so it is consistently 15Ú32" below the top of the table.

Figure 8. Rear rail attachment procedure.

3.Attach the front rail to the table top using the hex socket flathead screws supplied. See Figure 9. Place a combination square set at 25Ú32", at the edge of the table, and adjust the rail so it is consistently 25Ú32" below the top of the table.

Figure 9. Front rail attachment procedure. G7209/10 14'' Table Saw

Image 16
Contents Professional Cabinet SAW Model G7209 and G7210Page Table of Contents Safety Safety Instructions For Power ToolsLength AMP Rating Additional Safety Instructions For Table Saws Safety Accessories Push Paddles Common Definitions, Terms and Phrases 220V Single-Phase 220V Three-Phase Circuit RequirementsWiring Diagram Grounding Extension CordsIntroduction CommentaryUnpacking Piece InventoryClean up Site ConsiderationsBeginning Assembly AssemblyExtension Wings Using tape to shim for wing alignment Fence RailsSaw Blade Guard Support ShaftMotor Bracket Guard assembly square to table Blade Guard/SplitterAdjusted rear Table Insert Blade Height AdjustmentsBlade Tilt Miter Slot to Blade #1#3 #2#4 Miter Gauge Rip Fence SquareBlade Alignment Nylon PadsBlade Adjustment Cap Screw Arbor Bracket Pre-Run Check OperationsTest Run Blade Selection Ripping bladeCrosscutting Various saw tooth cutting profilesRipping Cross-cut operationDado Operations Optional dado blade systemRabbet Operations Sacrificial fenceRip Fence Sacrificial Fence Wood Stock Dado Blade Maintenance GeneralV-BeltTo adjust V-belt tension LubricationClosure Machine Data Sheet Grizzly Model G7210 14 Table SAW HP Magnetic Switch -NHD Type 2 HP Magnetic Switch -NHD Type 329 Page 45 53A 5856 62A 62 62B Page Description Description Troubleshooting Guide Symptom Possible Cause Corrective ActionCUT Here to Push 1⁄4 Wood CUT Here to Push 1⁄2 Wood Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC
Related manuals
Manual 52 pages 34.96 Kb