Grizzly G7209 instruction manual #1#3 #2#4

10.Refer to Figures 24 and 25, for shim place- ment. If the distance of A is longer than B, shim(s) will need to be placed under corners #1 and #2. If the distance of B is longer than A, shim(s) will need to be placed under cor- ners #3 and #4. Very thin shim stock works well, just make sure they are all the same thickness, and you put an equal number under each of the two corners.

11.Tighten down one bolt a small amount and then move on to each of the others, tighten- ing each down the same amount. Continue to rotate through the bolts, tightening them a little each time until they are all secure.

12.Now recheck the blade to miter slot at 90¡ and 45¡ by repeating Steps 1-5. If the dis- tance of A and B are equal to or less than 1Ú64" at both 90¡ and 45¡, continue to the ÒMiter GaugeÓ instructions. If the distances are still off by more than 1Ú64", repeat Steps 9- 12.

13.Once you feel you have the miter slot adjust- ed to the blade, recheck all measurements and be sure the table mounting bolts are secure. Repeat Step 10 in Section 4: Assembly, ÒBlade Guard/Splitter. Also, if you ever remove the table in the future, be sure to make note of shim placements and reassemble exactly how it came apart.

Blade tilted to 45¡

#1#3

#2#4

Figure 24.

Blade tilted to 45¡

#1#3

#2#4

Figure 25.