Grizzly G7209 instruction manual Blade Alignment, Nylon Pads

Page 25

Setscrews

Nylon Pads

Figure 28.

PARALLELISM

Align the fence alongside the miter slot as shown in Figure 29, and lock it down. If the fence is not perfectly parallel to the miter slot:

1.Release the clamping mechanism.

2.Remove the fence from the saw and adjust the setscrews on the rear side of the front bracket as shown in Figure 28. Make VERY minor adjustments and recheck by reclamp- ing the fence along the miter slot after each adjustment. Keep in mind that a small turn of the setscrew can make a large difference over the length of the fence. Be sure clamp- ing pressure is still adequate.

Figure 29.

G7209/10 14'' Table Saw

Blade Alignment

The blade position can be adjusted slightly in case it contacts the table insert when raised or tilted. This adjustment can be made by moving the table, the whole trunnion assemble, or by just moving the arbor bracket. Try adjusting by mov- ing the table first as this is the easiest way. If that doesnÕt work, try adjusting the whole trunion assembly. If that still doesnÕt work, try moving the arbor bracket.

To adjust the blade position by moving the table:

1.Disconnect plug from power source.

2.Loosen the four table mounting bolts.

3.Nudge the table to either the left or right depending on where the blade is hitting the saw. Tighten all mounting bolts.

4.If the blade is still contacting the insert, repeat Steps 1-3. Check all other adjust- ments.

5.Recheck the blade to miter slot adjustments, and adjust as necessary.

To adjust the blade position by moving the trun- nion:

1.Disconnect plug from power source.

Figure 30A. Trunnion mounting bolts.

-23-

Image 25
Contents Model G7209 and G7210 Professional Cabinet SAWPage Table of Contents Safety Instructions For Power Tools SafetyLength AMP Rating Additional Safety Instructions For Table Saws Safety Accessories Push Paddles Common Definitions, Terms and Phrases Circuit Requirements 220V Single-Phase 220V Three-PhaseGrounding Extension Cords Wiring DiagramCommentary IntroductionPiece Inventory UnpackingSite Considerations Clean upBeginning Assembly AssemblyExtension Wings Fence Rails Using tape to shim for wing alignmentSaw Blade Guard Support ShaftMotor Bracket Blade Guard/Splitter Guard assembly square to tableAdjusted rear Table Insert Blade Height AdjustmentsBlade Tilt Miter Slot to Blade #1#3 #2#4 Square Miter Gauge Rip FenceNylon Pads Blade AlignmentBlade Adjustment Cap Screw Arbor Bracket Pre-Run Check OperationsTest Run Ripping blade Blade SelectionVarious saw tooth cutting profiles CrosscuttingCross-cut operation RippingOptional dado blade system Dado OperationsSacrificial fence Rabbet OperationsRip Fence Sacrificial Fence Wood Stock Dado Blade GeneralV-Belt MaintenanceLubrication To adjust V-belt tensionClosure Machine Data Sheet Grizzly Model G7210 14 Table SAW HP Magnetic Switch -NHD Type 2 HP Magnetic Switch -NHD Type 329 Page 45 53A 5856 62A 62 62B Page Description Description Symptom Possible Cause Corrective Action Troubleshooting GuideCUT Here to Push 1⁄4 Wood CUT Here to Push 1⁄2 Wood Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC
Related manuals
Manual 52 pages 34.96 Kb