Grizzly G7209 instruction manual Blade Guard/Splitter, Guard assembly square to table

Page 18

Your saw comes from the factory with a red motor bracket designed to protect the motor assembly during shipping. Remove the bracket shown in

Figure 10C.

Blade Guard/Splitter

1.Slip the blade guard/splitter over the mount- ing bolts as shown in Figure 12. The wash- ers should be between the bolt head and the slots. Tighten the bolts to secure the blade guard/splitter.

Blade Guard

Washer

Mounting Bolt

Guard Support

Figure 12. Blade guard and splitter in place.

2.Set a machinistÕs square against the face of the blade guard/splitter. Slightly rotate the rear bracket to adjust the face of the blade guard perpendicular to the table top as shown in Figure 13.

Figure 13. Guard assembly square to table.

-16-

The saw blade is extremely sharp. Use extra care when handling the blade or working near it. Serious injury is possible.

3.Next, set a straightedge against the face of the saw blade and the blade guard/splitter as shown in Figure 14. If the blade guard/split- ter is properly aligned, please skip ahead to ÒTable InsertÓ; otherwise, continue with the next step.

Figure 14. Guard in line with blade.

4.If the blade guard/splitter is to the right of the blade as shown in Figure 15, simply add washers between the splitter and front mounting bracket, and adjust the rear splitter support as shown in Figure 16.

Adjust here to move back of splitter left or right.

Table Surface

Splitter

Add washers here to move front of

splitter to the left.

Blade

Figure 15. Improper splitter/blade alignment. G7209/10 14'' Table Saw

Image 18
Contents Professional Cabinet SAW Model G7209 and G7210Page Table of Contents Safety Safety Instructions For Power ToolsLength AMP Rating Additional Safety Instructions For Table Saws Safety Accessories Push Paddles Common Definitions, Terms and Phrases 220V Single-Phase 220V Three-Phase Circuit RequirementsWiring Diagram Grounding Extension CordsIntroduction CommentaryUnpacking Piece InventoryClean up Site ConsiderationsAssembly Beginning AssemblyExtension Wings Using tape to shim for wing alignment Fence RailsGuard Support Shaft Saw BladeMotor Bracket Guard assembly square to table Blade Guard/SplitterAdjusted rear Table Insert Adjustments Blade HeightBlade Tilt Miter Slot to Blade #1#3 #2#4 Miter Gauge Rip Fence SquareBlade Alignment Nylon PadsBlade Adjustment Cap Screw Arbor Bracket Operations Pre-Run CheckTest Run Blade Selection Ripping bladeCrosscutting Various saw tooth cutting profilesRipping Cross-cut operationDado Operations Optional dado blade systemRabbet Operations Sacrificial fenceRip Fence Sacrificial Fence Wood Stock Dado Blade Maintenance GeneralV-BeltTo adjust V-belt tension LubricationClosure Machine Data Sheet Grizzly Model G7210 14 Table SAW HP Magnetic Switch -NHD Type 2 HP Magnetic Switch -NHD Type 329 Page 45 53A 5856 62A 62 62B Page Description Description Troubleshooting Guide Symptom Possible Cause Corrective ActionCUT Here to Push 1⁄4 Wood CUT Here to Push 1⁄2 Wood Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC
Related manuals
Manual 52 pages 34.96 Kb