Operation Instructions

1.Before use, add a few drops of pneumatic tool oil (not included) into the Inlet.

2.Attach the Air Coupler (61) to Air Inlet using pipe thread seal tape (not included). Then connect the 3/8” Air Source Hose to the Nailer.

3.Set the working air pressure on the regulator to between 60 and 100 PSI.

Do not exceed 100 Max. PSI.

4.Set the Adjusting Dial (46) to match the corresponding size (1/2”, 5/8”, 3/4”, 7/8” or 1”) of the fasteners loaded in the Nailer.

Note: When changing pin size, turn the Adjusting Dial to the new depth size BEFORE inserting the new pins.

5.Slide the Safety (60) to the side so that the Trigger (27) will function. When ready, press down on the Trigger (27) to operate.

6.Test before first use by driving nails into a sample piece of wood. If the fasteners do not achieve the desired penetration, adjust the air pressure to a higher setting until desired penetration is achieved.

7.Always make sure the Bracket (40) is flush against the workpiece during use. Always release the Trigger (27) once the fastener is driven into the workpiece.

8.When ready to operate the Nailer, press down on the Trigger (27). Make sure the Nailer does not cycle during use. Never use the Nailer if a cycle occurs.

Rev 10f

9.In case of a fastener jam, take your finger off the Trigger (27). Rotate the

Trigger Lock/Safety (60) clockwise or counter-clockwise. For instance, a “6 o-clock” position will lock the

Trigger (27) and the tool will not fire.

However, “3 o-clock” and “9 o-clock” positions unlock the Trigger (27), allowing the tool to fire.

Note: There is no contact safety for the Trigger (27). When the Trigger Lock/ Safety (60) is disengaged, the Nailer will fire.

10.Turn off the air supply and disconnect the Nailer from the regulator. Open the Nozzle (40) and clear the jammed fasteners with a pair of pliers (not included).

If a jam occurs inside the magazine, depress the upper tip of the Click Lever (59). The Side Cover (34) will pop open. If needed, open the Nozzle (40) to help clear the jam. Once the jam is cleared, push the Side Cover (34) back into place and latch tight using the Click Lever (59).

SKU 97526

For technical questions, please call 1-800-444-3353.

Page 6