Harbor Freight Tools 97520 operating instructions SKU For technical questions, please call

6.Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts. Protective, electrically non-conductive clothes and non-skid foot- wear are recommended when working. Wear restrictive hair covering to contain long hair.

7.Do not overreach. Keep proper footing and balance at all times. Do not reach over or across running machines or air hoses.

8.Use eye and ear protection. Always wear ANSI approved impact safety goggles and appropriate hearing protection. Wear a full face shield if you are producing metal filings or wood chips. Wear a NIOSH approved dust mask or respirator when working around metal, wood, and chemical dusts and mists. Other people in the work area must also wear ANSI approved impact safety goggles.

9.Maintain tools with care. Keep tools clean for better and safer performance. Follow instructions for lubricating and changing accessories. Inspect tool cords and air hoses periodically and, if damaged, have them repaired by a qualified technician. The handle must be kept clean, dry, and free from oil and grease at all times. Do not operate a tool if any portion of the tool’s operating controls are inoperable, disconnected, altered, or not working properly.

10.Disconnect air hose and release any built-up air pressure. Never service the Nailer, clear jams, or disassemble with the air hose attached. Always release any built-up air even after disconnecting hose. Disconnect the Nailer when not in use.

11.Remove adjusting wrenches. Check that adjusting wrenches are removed from the tool or machine work surface before attaching to an air source.

12.Avoid unintentional starting. Be sure the trigger is in the OFF position when not in use and before plugging in. Do not carry any tool with your finger on the trigger, whether it is attached to an air source or not. Do not point the tool towards yourself or anyone whether it contains brads or not.

13.Stay alert. Watch what you are doing. Use common sense. Do not operate any tool when you are tired.

14.Check for damaged parts. Before using any tool, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts, any broken parts or mounting fixtures, and any other condition that may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified technician. Do not use the tool if the trigger does not operate properly.

SKU 94481 For technical questions, please call 1-800-444-3353 PAGE 3