Global Machinery Company LS211 Setting the fence square with the table, Loosen the mitre locks

Page 12

3.Loosen the mitre locks (15).

4.Rotate the table (12) until the pointer is positioned at 0º.

5.Tighten the mitre locks (15).

6.Loosen the bevel lock (7) and set the saw arm (1) at 0º bevel (the blade at 90º to the mitre table). Tighten the bevel lock (7).

7.Place a set square against

the table (12) and the flat J

part of the blade (fig. J).

Note. Make sure that the

90

 

0

square contacts the flat

 

part of the saw blade, not

 

the teeth.

 

8.Rotate the blade by hand and check the blade-to-table alignment

at several points.

K

9.The edge of the set square and the saw blade should be parallel.

10.If the saw blade angles away from the set square, adjust as follows.

11.Use an 8mm wrench or adjustable wrench

to loosen the lock nut

L

securing the 0° bevel

 

13. Loosen the Phillips head screw holding the pointer M of the bevel scale (8)

and adjust the position of the pointer so that it accurately indicates zero on the scale. Retighten the screw (fig. M).

14.Retighten the bevel lock

(7) and the lock nut

securing the 0° bevel adjustment screw (10).

Note. The above procedure can also be used to check the angle of the saw blade to the table at 45º bevel angle. The 45° bevel adjustment screw (9) is on the opposite side of the saw arm.

Setting the fence square with the table

1.Make sure that the electrical plug is removed from the power point.

2.Push the saw arm (1) down

to its lowest position and N

engage the release knob (2) to hold the saw arm in the transport position.

3.Loosen the mitre locks (15).

4.Rotate the table (12) until the pointer is positioned at 0º.

5.Tighten the mitre locks (15).

adjustment screw (10).

Also, loosen the bevel

lock (7) (fig. K).

12.Adjust the 0° bevel adjustment screw (10) using a 4mm hex key to bring the saw blade into alignment with the square (fig. L).

6.Using a 5mm hex key, loosen the two screws securing the fence (11) to the base (fig. N).

7.Place a square against the fence (11) and alongside the blade (fig. O).

8.Adjust the fence (11) until it is square with the blade.

O

90

9. Tighten the screws securing the fence (11).

12

Image 12
Contents 210mm 8 1/4 Compound Mitre Saw Contents Description of symbols SpecificationsDear Customer IntroductionSafety rules for laser lights General safety instructionsPage Additional safety rules for mitre saws Wear gloves when handling saw blades and rough materials Take additional care when trenching slottingAccessories Saw blade fiited 6mm Hex Key Receipt holderMitre table Laser light Mitre scale On/off switch Know your productBlade bolt cover Bevel lock 6mm Hex key Bevel scaleUnpacking TransportationBench mounting Release knobSetting the table square with the blade Mitre table locksBevel lock Spindle lock buttonSetting the fence square with the table Loosen the mitre locksTighten the mitre locks Lock 7 fig. KChanging a blade Raise the saw arm 1 to its highest positionPull the rotating blade Guard 5 down then Blade bolt fig. S Hold the rotating guard Up and pressOperation Cross cut Bevel cutCompound mitre cut Loosen the bevel lock 7 and move the saw armAdjusting the laser line Using the laser line generatorMaintenance Power cord maintenance CleaningGeneral inspection Page Page Save this Manual for future reference