Global Machinery Company LS211 instruction manual Save this Manual for future reference

Page 20

Carefully read the entire Instruction Manual before using this product.

Before returning this product for a Warranty Claim or any other reason Please Call 1300 880 001 (Australia) or 0800 445 721 (New Zealand)

When you make your call, please have the following information at hand:

•GMC Product Type • GMC Product Code

A GMC Service Engineer will take your call and, in most cases, will be able to solve your problem over the phone.

You are welcome to use this phone-in service to make suggestions or give comments about any GMC product.

With continuing product development changes may have occurred which render the product received slightly different to that shown in this instruction manual. The manufacturer reserves the right to change specifications without notice. Note: Specifications may differ from country to country.

The GMC 777 Helpline operates from 7am to 7pm, 7 days a week (EST). This allows you to contact GMC directly with any queries and technical questions you have regarding

our products.

45–55 South Centre Road

Melbourne Airport

Victoria, Australia 3045

Tel: (03) 8346 1100 Fax: (03) 8346 1200

Save this Manual for future reference.

Page 19 Page 20
Image 20
Page 19 Page 20
Contents 210mm 8 1/4 Compound Mitre Saw Contents Description of symbols SpecificationsDear Customer IntroductionSafety rules for laser lights General safety instructionsPage Additional safety rules for mitre saws Wear gloves when handling saw blades and rough materials Take additional care when trenching slottingAccessories Saw blade fiited 6mm Hex Key Receipt holderMitre table Laser light Mitre scale On/off switch Know your productBlade bolt cover Bevel lock 6mm Hex key Bevel scaleUnpacking TransportationBench mounting Release knobSetting the table square with the blade Mitre table locksBevel lock Spindle lock buttonSetting the fence square with the table Loosen the mitre locksTighten the mitre locks Lock 7 fig. KChanging a blade Raise the saw arm 1 to its highest positionPull the rotating blade Guard 5 down then Blade bolt fig. S Hold the rotating guard Up and pressOperation Cross cut Bevel cutCompound mitre cut Loosen the bevel lock 7 and move the saw armAdjusting the laser line Using the laser line generatorGeneral inspection Maintenance Power cord maintenanceCleaning Page Page Save this Manual for future reference
Top Page Image Contents