Global Machinery Company LS211 Adjusting the laser line, Using the laser line generator

Page 16

Adjusting the laser line

The laser is factory set to emit

 

 

 

 

b

 

a laser line along the middle

 

 

of the blade.

 

 

 

To adjust the position of the

 

 

 

laser, proceed as follows:

 

 

 

1. Switch on the laser light

 

 

 

with the laser on/off

 

 

 

switch (25) (fig. b).

 

 

 

2. Using a Phillips head

 

 

 

 

 

 

screwdriver loosen the 2

 

 

 

 

 

 

screws securing the laser

 

c

light assembly (24)

 

 

 

(fig. c).

 

 

 

3.Adjust the laser assembly until the laser line is

in the desired position

– centred with the blade (fig. d), to the left of the blade or to the right of the blade.

4. Switch off the laser light.

d

Using the laser line generator

WARNINGS.

Do not stare directly at the laser beam.

Never aim the beam at any

person or an object other than the workpiece.

Do not deliberately aim the beam at personnel and ensure that it is not directed towards the eye of a person for longer than 0.25s.

Always ensure the laser beam is aimed at a sturdy workpiece without reflective surfaces. Wood or rough coated surfaces are acceptable. Bright shiny reflective surfaces are not suitable for laser use as the reflective surface could direct the beam back at the operator.

Always remember to switch off the laser on/off switch

(25)after finishing a job. Only turn the laser beam on when the workpiece is on the mitre saw table.

1.Mark the line of the cut on the workpiece.

2.Adjust the angle of mitre and bevel of the cut as required.

3.Switch on the laser light on/off switch (25).

4.Place the workpiece in position using the laser lines to align the blade with the pencil mark on the workpiece.

5.Plug in the machine and start the motor.

6.Press the release latch (17).

7.When the blade is at its maximum speed (approximately 2 seconds), lower the blade through the workpiece.

8.After completing the cut, switch off the laser light on/ off switch (25).

9.After each use, clean the laser light assembly (24) as described below:

•Switch off the laser light switch (25) and remove the plug from the power point.

•With the saw arm (1) in the raised position, use a soft brush to dust away the sawdust build-up around the assembly.

Note. Wear eye protection whilst brushing the dust away.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents 210mm 8 1/4 Compound Mitre Saw Contents Description of symbols SpecificationsDear Customer IntroductionSafety rules for laser lights General safety instructionsPage Additional safety rules for mitre saws Wear gloves when handling saw blades and rough materials Take additional care when trenching slottingAccessories Saw blade fiited 6mm Hex Key Receipt holderMitre table Laser light Mitre scale On/off switch Know your productBlade bolt cover Bevel lock 6mm Hex key Bevel scaleUnpacking TransportationBench mounting Release knobSetting the table square with the blade Mitre table locksBevel lock Spindle lock buttonSetting the fence square with the table Loosen the mitre locksTighten the mitre locks Lock 7 fig. KChanging a blade Raise the saw arm 1 to its highest positionPull the rotating blade Guard 5 down then Blade bolt fig. S Hold the rotating guard Up and pressOperation Cross cut Bevel cutCompound mitre cut Loosen the bevel lock 7 and move the saw armAdjusting the laser line Using the laser line generatorCleaning Maintenance Power cord maintenanceGeneral inspection Page Page Save this Manual for future reference
Top Page Image Contents