Global Machinery Company LS211 Changing a blade, Raise the saw arm 1 to its highest position

Page 13

10. Loosen the Phillips head screw holding the pointer P of the mitre scale (13)

and adjust it so that it accurately indicates the zero position on the mitre scale (fig. P).

11.Retighten the screw securing the mitre scale pointer.

Changing a blade

DANGER! Never try to use a blade larger than the stated capacity of the saw. It might come into contact with the blade guards. Never use a blade that is too thick to allow the outer blade washer to engage with the flats on the spindle. It will prevent the blade screw from properly securing the blade on the spindle. Do not use the saw to cut metal or masonry. Ensure that any spacers and spindle rings that may be required suit the spindle and the blade fitted.

1.Make sure that the electrical plug is removed from the power point.

2.Push down on the operating handle (3) and pull the release knob (2) to disengage the saw arm (1).

3.Raise the saw arm (1) to its highest position.

4.Using a Phillips head screwdriver loosen and remove the Phillips head screw that secures the guard retraction arm (6) to the rotating blade guard (5) (fig. Q).

5.Using a Phillips head screwdriver loosen the Phillips head screw that secures the blade bolt cover (19) (fig. R).

Q

 

R

 

 

 

6. Pull the rotating blade

 

S

guard (5) down then

swing it up together with

 

the blade bolt cover (19).

 

When the rotating blade

 

guard (5) is positioned over

 

the upper fixed blade guard

 

(4) it is possible to access

 

the blade bolt (fig. S).

 

7. Hold the rotating guard

 

(5) up and press the

T

spindle lock button (18).

 

Rotate the blade until the

 

spindle locks (fig. T).

 

8.Use the 6mm hex key provided to loosen and remove the blade bolt. (Loosen in a clockwise direction as the blade

screw has a left hand thread) (fig. U).

U

 

V

 

 

 

9. Remove the flat washer,

outer blade washer and W the blade (fig. V).

10.Wipe a drop of oil onto the inner blade washer and the outer blade washer where they contact the blade.

11.Fit the new blade onto the spindle taking care

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents 210mm 8 1/4 Compound Mitre Saw Contents Specifications Description of symbolsDear Customer IntroductionGeneral safety instructions Safety rules for laser lightsPage Additional safety rules for mitre saws Take additional care when trenching slotting Wear gloves when handling saw blades and rough materialsSaw blade fiited 6mm Hex Key Receipt holder AccessoriesKnow your product Mitre table Laser light Mitre scale On/off switchBlade bolt cover Bevel lock 6mm Hex key Bevel scaleTransportation UnpackingBench mounting Release knobMitre table locks Setting the table square with the bladeBevel lock Spindle lock buttonLoosen the mitre locks Setting the fence square with the tableTighten the mitre locks Lock 7 fig. KRaise the saw arm 1 to its highest position Changing a bladePull the rotating blade Guard 5 down then Blade bolt fig. S Hold the rotating guard Up and pressBevel cut Operation Cross cutLoosen the bevel lock 7 and move the saw arm Compound mitre cutUsing the laser line generator Adjusting the laser lineCleaning Maintenance Power cord maintenanceGeneral inspection Page Page Save this Manual for future reference
Top Page Image Contents