5.Check daily the operation of the safety valve. This check should be performed when the tank contains close to max pressure in the tank.
To check the valve, pressurise the tank, and pull the ring OUTWARDS on the safety valve.
Air should discharge from the valve.
Release the ring of the safety valve. When the ring is released the air discharge must stop.
WARNINGS.
Safety glasses must be worn when performing this test.
Do not have your face close to the safety valve when performing this test as air will discharge from the valve at a high force.
If the safety valve does not operate correctly in any way as described above, turn off the compressor immediately and have the compressor and safety valve checked and tested at an authorised Service centre.
DO NOT CONTINUE TO USE THE COMPRESSOR IN ANY WAY IF THE SAFETY VALVE DOES NOT WORK AS ABOVE.
Cleaning
1.Keep the tool’s air vents unclogged and clean at all times.
2.Remove dust and dirt regularly. Cleaning is best done with a soft brush or a rag.
3.
4.If the body of the compressor needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used but nothing like alcohol, petrol or other cleaning agent.
5.Never use caustic agents to clean plastic parts.
Caution. Water must never come into contact with the tool
Power cord maintenance
Only an authorised service centre should replace the cordset or carry out other repairs. If the cordset is damaged or worn, have it repaired or replaced by an authorised service centre.
General inspection
1.Regularly check that all the fixing screws are tight.
2.The supply cord of the tool should be checked frequently for damage. If damaged, have the cordset replaced by an authorised service facility to avoid
a hazard.
15
AC30G_AC40G15
12/8/05, 4:49 PM