Global Machinery Company instruction manual AC30GAC40G7 12/8/05, 448 PM

Page 7

To avoid the risk of burns and injury from moving parts, do not operate the compressor with the safety shield removed. Allow hot parts to cool before handling or servicing.

Be certain to read all the labels on the containers of paint or other materials to be sprayed. Closely follow all safety instructions. Use a respirator mask if there is a chance that you might otherwise inhale the spray material. Carefully check the effectiveness of any respirator mask you intend using.

Always wear safety goggles or glasses when using the air compressor. Never point the nozzle of an accessory towards any part of your body or towards another person.

Do not attempt to adjust the pressure switch or the release valve located under the pressure switch cover.

Drain the moisture from the tank daily. It will help prevent corrosion.

Pull the ring on the safety valve daily to ensure that it operating properly and to clear any possible instruc- tions.

Keep the compressor at least 300mm from the nearest wall to ensure adequate ventilation for cooling purposes.

Before transporting the compressor make sure that the pressurised air is bled from the tank and that the compressor is firmly secured.

Protect the air hose and cordset from damage. Inspect for weak or worn spots regularly and replace if necessary.

Do not use an extension cord with this product. Use additional air hose instead of an extension cord to prevent power loss and possible damage to the motor. Use of an extension cord voids the warranty.

After long working periods external metal parts could be hot.

Always press the on/off button down to switch off the compressor before switching off the power or removing the power plug.

Do not use the compressor without first checking the oil level. It must be close to the red circle as viewed on the oil gauge.

NOTE. The compressor is supplied empty of oil. It must be filled with oil before first use.

After using the compressor, switch off the on/off button, disconnect the power supply and open the outlet valve to release the pressure.

Do not attempt to remove any part of the machine whilst it is under pressure.

Ensure that the lubricating oil is clean and that the oil level is maintained at the correct level. Replace the oil as indicated in the Maintenance section of this Manual.

Use safety equipment including safety goggles or shield, ear protection, breathing or respirator mask and protective clothing.

Wear goggles.

Wear earmuffs.

Wear a breathing or respirator mask.

Never apply the outlet air of this compressor directly on to any part of a person’s body. Do not attempt to block the air outlet with your finger or any part of your body.

The tool must be used only for its prescribed purpose. Any use other than those mentioned in this Manual will be considered a case of misuse. The user and not the manu- facturer shall be liable for any damage or injury resulting from such cases of misuse.

The manufacturer shall not be liable for any changes made to the tool nor for any damage resulting from such changes.

7

AC30G_AC40G7

12/8/05, 4:48 PM

Image 7
Contents 2HP & 2.5HP Contents Operating Introduction Description of symbolsSpecifications Dear CustomerGeneral safety instructions Additional safety rules for air compressors AC30GAC40G7 12/8/05, 448 PM Contents of carton 114 Know your productUnpacking AssemblyTo start & stop the compressor Pre-start routineAir filter Operation Trouble Possible cause Possible remedy TroubleshootingVibration or abnormal noise Excessive oil consumption MaintenanceTrouble Possible cause Suggested Remedy Outlet capacityPower cord maintenance CleaningGeneral inspection Save this Manual for future reference